EverFocus UNI IP Series User Manual page 111

7.6.2.1 Motion Detection
You can configure the Motion Detection Alarm settings here:
Motion detection detects the object motion in a specified rectangular area during a period. You need to
set a detection area, sensitivity of detection, object size, and history for the camera to decide whether to
report a motion detection alarm when it detects motion.
NOTE!
1. This function is not supported by some models. Please see the actual model for details.
2. The alarm triggered actions may vary with models. Please see the actual Web interface for
details.
Area Detection
Click Setup > Events >Common Alarm >Motion Detection. Set Detection Mode to Area.
1. In the Detection Area, click
2. Click and drag the mouse to set a detection area.
3. Set the detection sensitivity, object size, and history for the camera to decide whether to report a
motion detection alarm.
Moving the slider to the right increases detection sensitivity. When the extent of motion

within the detection area exceeds the set object size, the camera reports an alarm.
Object size specifies the minimum ratio of the object's size to the size of the total detection

area before an alarm will be reported. That is to say, to detect motion of tiny objects, you
need to draw a small box (detection area) in the actual motion area accordingly.
Motion detection results are shown in real time. The red lines represent the raised motion

detection alarms. The longer a line, the greater the extent of motion. The denser the lines,
the greater the frequency of motion.
UNI IP Series Network Cameras – H265, 2MP / 5MP
to add a new detection area. To delete a detection area, click
104
.