Initial Configuration - EverFocus UNI IP Series User Manual

Button

3.2 Initial Configuration

After you log in to the device, please perform the following initial configuration.
Item
1. Ethernet.
2. Log out and log in again to the
Web using the new IP address.
3. Set the system time.
4. (Optional) Set the management
server.
5. (Optional) Set the server for
storing photos.
6. Set OSD.
7. (Optional) Manage users.
You can watch the live video after finishing the initial configuration. Please configure other parameters
as needed.
NOTE:
The displayed live view interface, parameters displayed and value ranges may vary with models.
Please see the actual Web interface for details.
The parameters that are grayed out cannot be modified. For the actual settings, see the Web
interface.
It is recommended that you change the password when you are logged in the first time. For
details about how to change a password, please refer to 7.8 Security
for around 3 seconds or leaves the window, the information disappears.
Click this button to open the image setting page.
Display in full screen mode.
Select a live video stream that the camera supports: main stream, sub
stream or third stream.
Description
Reconfigure the device IP and network parameters
based on the actual networking.
-
Set the system time based on the actual situation.
Set the management server based on the actual
networking.
Set the server for storing photos based on the actual
networking.
Set the information displayed on the screen as
needed, for example, time.
Change the default password and add common users
as needed.
10
UNI IP Series Network Cameras – H265, 2MP / 5MP
Description