Table of Contents
Advertisement
b.
If the same alarm is triggered within the set time, the alarm will not be cleared until the
suppress alarm time expires. Then the same alarm can be reported again.
4.
Set actions to be triggered by motion detection alarm and the plan. For the detailed steps, see the
descriptions of alarm-triggered actions in Area Detection, please refer to 7.6.2.1 Configuring
Motion Detection Alarm.
5.
Click Save.
7.6.2.2
Tampering Alarm
Configure tampering alarm so that the camera reports a tampering alarm when the lens is blocked for a
certain length of time.
NOTE!
1. This function is not supported by some models. Please see the actual model for details.
2. The alarm triggered actions may vary with models. Please see the actual Web interface for
details.
Click Setup>Events>Common Alarm >Tampering Alarm.
1.
Select On for Tampering Alarm.
2.
Set detection sensitivity and duration for the camera to decide whether to report a tampering
alarm. Sensitivity is divided into three levels: high-level, mid-level and low-level. Compared with
mid-level sensitivity, the camera can detect blocking from a farther location when sensitivity is set
to high. The camera reports an alarm when the lens is blocked for a specified length of time.
3. Tampering alarm is effective to the whole screen. To disable tampering alarm, clear the Tampering
Alarm check box.
4.
Set actions to be triggered by tampering alarms and the plan. For the detailed steps, see the
descriptions of alarm-triggered actions in 7.6.2 Configuring Motion Detection Alarm.
5.
Click Save.
UNI IP Series Network Cameras – H265, 2MP / 5MP
106
Advertisement
Table of Contents
