Power On Message And Function Message; Power On Message; Function Message - Kenwood TH-78A Instruction Manual

POWER ON MESSAGE AND FUNCTION MESSAGE

1 Power On Message

When you first switch the POWER on, "TH78A" or
"TH78E" appears on the display for two seconds.
You can change this factory-set message to your
own message as follows:
Changing Power-on Message
1 Select your message by following steps 1 to 4 of the
memory write procedure on page 44.
2 Press the 0 key.
The power-on message has now been changed. If
you switch the power off and on again, your own
message will be displayed on the display for two
seconds.
j NOTE
The above message, which is stored in message
memory channel 0, appears each time you switch
the power on.

2 Function Message

When you select a function, the corresponding
function message is displayed on the LCD for two
seconds.
The message and functions are listed below.
Message
AF CHG
Transpose the two AF bands
AF INI
Initial AF output setting
AF MIX
Mix the AF output from both bands
AF SEP
Separate the AF output into two bands
AS OFF
Automatic offsets OFF
AS ON
Automatic offsets ON
BELL 1
Tone alert (Telephone type ring)
BELL 2
Tone alert (Tone alarm)
BP OFF
Beep OFF
BP ON
Beep ON
DTMF0S
No DTMF signal transmission delay time
DTMF2S
Setting DTMF signal transmission delay time
(two seconds)
Function
57