Bezel
Figure 96. Bezel installation
Step 3.
Reinstall the video connector screws.
Step 4.
Reinstall the hard disk drives and drive bay filler panels into the drive bays.
Step 5.
Install the cover (see
Step 6.
Reconnect the power cords and any cables that you removed.
Step 7.
Slide the server into the rack.
Step 8.
Turn on the peripheral devices and the server.
Removing an optional optical drive cage
Use this information to remove an optional optical drive cage.
To remove an optional optical drive cage, complete the following steps:
Step 1.
Read the safety information that begins on
417.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords.
Step 3.
Remove the cover (see
Step 4.
Remove the DVD cable (see
Step 5.
Remove the DVD drive (see
Step 6.
Remove the bezel (see
Step 7.
Slide the optional optical drive cage out of the chassis and set it aside.
System x3550 M3Problem Determination and Service Guide
482
"Installing the cover" on page
"Safety" on page v
"Removing the cover" on page
"Removing the DVD cable" on page
"Removing an optional DVD drive" on page
"Removing the bezel" on page
Bezel
425).
and
"Installation guidelines" on page
424).
484).
441).
480).