Table of Contents
Advertisement
Table 9. DSA Preboot messages (continued)
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
Chapter 4 "Parts listing, Lenovo System x3550 M3 Type 4254 and 7944" on page 403
• See
components are customer replaceable units (CRU) and which components are field replaceable units (FRU).
• If an action step is preceded by "(Trained service technician only)", that step must be performed only by a
Trained service technician.
• Go to the IBM support website at
tips, and new device drivers or to submit a request for information.
Message
Compo-
number
nent
202-802-
Memory
xxx
http://www.ibm.com/supportportal/
Description
Test
State
Memory
Failed
General
Stress
error:
Test
memory size
is insufficient
to run the
test.
to determine which
to check for technical information, hints,
Action
4. Run the test again.
5. Turn off and restart the system if necessary
to recover from a hung state.
6. Run the memory diagnostics to identify the
specific failing DIMM.
7. If the failure remains, go to the IBM website
for more troubleshooting information at
http://www.ibm.com/support/entry/portal/
docdisplay?lndocid=SERV-CALL
1. Make sure that all memory is enabled by
checking the Available System Memory in
the Resource Utilization section of the DSA
event log. If necessary, enable all memory in
the Setup utility (see
"Using the Setup utility"
on page
517).
2. Make sure that the DSA code is at the latest
level. For the latest level of DSA code, go to
http://www.ibm.com/support/entry/portal/
docdisplay?lndocid=SERV-DSA
3. Run the test again.
4. Run the standard memory test to validate all
memory.
5. If the failure remains, go to the IBM website
for more troubleshooting information at
http://www.ibm.com/support/entry/portal/
docdisplay?lndocid=SERV-CALL
Chapter 3
.
.
.
.
Diagnostics
349
Advertisement
Table of Contents
