Table of Contents
Advertisement
Figure 83. Adapter installation
Step 12. Slide the port connectors on the adapter into the port openings on the chassis; then, press the
adapter firmly until the two standoffs engage the adapter. Make sure the adapter is securely seated
on the connector on the system board. Make sure the port connectors on the adapter do not set on
the rubber stopper. The following illustration shows the side view of the adapter in the server.
Ethernet ports
Chassis
Figure 84. Adapter installation
Attention: Make sure the port connectors on the adapter are aligned properly with the chassis on
the rear of the server. An incorrectly seated adapter might cause damage to the system board or
the adapter.
Figure 85. Port connectors
Step 13. Reinstall the PCI riser-card assembly in PCI riser connector 1 if you have removed it previously (see
"Installing a PCI riser-card assembly" on page
System x3550 M3Problem Determination and Service Guide
474
Adapter
System board
Rubber
stopper
487).
Advertisement
Table of Contents
