Lenovo System x3550 M3 Problem Determination And Service Manual page 434

Figure 24. Operator information panel cable connection
The following illustration shows the internal routing and connector for the USB/video cable. The following
notes describes other information you must consider when you install or remove the USB/video cable:
• You may remove the optional optical drive cable to obtain more room before you install or remove the
operator information panel cable.
• The USB/video cable is routed under the video cable and then both the USB and video cables are routed
under the cable retention tab and the top cover latch receptacle.
• To remove the USB/video cable, slightly press the cable toward the chassis; then, pull to remove the
cable from the connector on the system board. Pulling the cable out of the connector by excessive force
might cause damage to the cable or connector.
• To connect the USB/video cable on the system board, press evenly on the cable. Pressing on one side of
the cable might cause damage to the cable or connector.
System x3550 M3Problem Determination and Service Guide
422