Table of Contents
Advertisement
To install the replacement system-board battery, complete the following steps:
Step 1.
Follow any special handling and installation instructions that come with the replacement battery.
Step 2.
Insert the new battery:
a.
Tilt the battery so that you can insert it into the socket on the side opposite the battery clip.
Figure 93. Battery installation
b.
Press the battery down into the socket until it clicks into place. Make sure that the battery clip
holds the battery securely.
c.
If you removed a rubber cover from the battery holder, use your fingers to install the battery
cover on top of the battery connector.
Step 3.
Install the cover (see
Step 4.
Slide the server into the rack.
Step 5.
Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices
and the server.
Step 6.
Start the Setup utility and reset the configuration.
• Set the system date and time.
• Set the power-on password.
• Reconfigure the server.
See
"Using the Setup utility" on page 517
Removing and replacing Tier 2 CRUs
You may install a Tier 2 CRU yourself or request IBM to install it, at no additional charge, under the type of
warranty service that is designated for your server.
Note: The illustrations in this document might differ slightly from your hardware.
Removing the bezel
Use this information to remove the bezel.
To remove the bezel, complete the following steps:
Step 1.
Read the safety information that begins on
417.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords.
Step 3.
Remove the cover (see
Step 4.
Remove the hard disk drives and filler panels from the hard disk drive bays.
Step 5.
Remove the screws from the bezel.
System x3550 M3Problem Determination and Service Guide
480
"Installing the cover" on page
for details.
"Safety" on page v
"Removing the cover" on page
425).
and
"Installation guidelines" on page
424).
Advertisement
Table of Contents
