Table of Contents
Advertisement
SW4 switch block
Figure 19. UEFI boot recovery jumper block (J29) location
Step 5.
Remove any adapters that impede access to the UEFI boot recovery jumper block (J29), see
"Removing an adapter" on page
Step 6.
Move the jumper from pins 1 and 2 to pins 2 and 3 to enable the UEFI recovery mode.
Step 7.
Reinstall any adapter that you removed before (see
Step 8.
Reinstall the server cover (see
Step 9.
Restart the server. The power-on self-test (POST) starts.
Step 10. Boot the server to an operating system that is supported by the firmware update package that you
downloaded.
Step 11. Perform the firmware update by following the instructions that are in the firmware update package
readme file.
Step 12. Copy the downloaded firmware update package into a directory.
Step 13. From a command line, type filename-s, where filename is the name of the executable file that you
downloaded with the firmware update package. Monitor the firmware update until completion.
Step 14. Turn off the server and disconnect all power cords and external cables, and then remove the server
cover (see
"Removing the cover" on page
Step 15. Remove any adapters that impede access to the UEFI boot recovery jumper block (J29) (see
"Replacing an adapter" on page
uEFI boot recovery
jumper (J29)
SW3 switch block
447.
"Installing the cover" on page
424).
448).
IMM recovery
jumper (J147)
"Replacing an adapter" on page
425); then, reconnect all power cords.
Chapter 3
448).
.
Diagnostics
397
Advertisement
Table of Contents
