Table of Contents
Advertisement
Figure 63. ServeRAID-M10i adapter cable connection
Step 10. Reconnect the power cord and any cables that you removed.
Step 11. Replace the cover (see
Step 12. Turn on the peripheral devices and the server.
Note: When you restart the server, you are prompted to import the existing RAID configuration to
the new SAS/SATA adapter.
Removing an optional ServeRAID adapter advanced feature key
Use this information to remove an optional ServeRAID adapter advanced feature key.
To remove an optional ServeRAID adapter advanced feature key, complete the following steps:
Step 1.
Read the safety information that begins on
417.
Step 2.
Turn off the server and peripheral devices and disconnect all power cords.
Step 3.
Remove the cover (see
Step 4.
Grasp the feature key and lift to remove it from connector on the ServeRAID adapter.
"Installing the cover" on page
"Safety" on page v
"Removing the cover" on page
425).
and
"Installation guidelines" on page
424).
.
Chapter 5
Removing and replacing components
457
Advertisement
Table of Contents
