Table of Contents
Advertisement
Figure 111. Backplate assembly cable connection
Step 7.
Reinstall the hard disk drives and filler panels.
Step 8.
Install the cover (see
Step 9.
Slide the server into the rack.
Step 10. Reconnect the power cords and any cables that you removed.
Step 11. Turn on the peripheral devices and the server.
Removing the operator information panel assembly
Use this information to remove the operator information panel assembly.
To remove the operator information panel, complete the following steps.
Step 1.
Read the safety information that begins on
417.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords and all external cables.
Step 3.
Remove the cover (see
Step 4.
Disconnect the cable from the back of the operator information panel assembly.
Step 5.
Use an object to push down on the release tab; hold down the release tab and push the blue push
point on the rear of the panel to the front of the server.
System x3550 M3Problem Determination and Service Guide
494
"Installing the cover" on page
"Safety" on page v
"Removing the cover" on page
425).
and
"Installation guidelines" on page
424).
Advertisement
Table of Contents
