Table of Contents
Advertisement
Figure 51. DVD drive cable connection
Step 13. Reconnect the power cord and any cables that you removed.
Step 14. Turn on the peripheral devices and the server.
Removing an adapter
Use this information to remove an adapter.
To remove an adapter, complete the following steps:
Step 1.
Read the safety information that begins on
417.
Step 2.
Turn off the server and peripheral devices and disconnect all power cords.
Step 3.
Remove the cover (see
Step 4.
Disconnect any cables from the adapter.
Step 5.
Grasp the riser-card assembly at the rear edge and lift to remove the riser-card assembly.
Step 6.
Place the riser-card assembly on a flat, static-protective surface.
Step 7.
Carefully grasp the adapter by its top edge or upper corners, and pull the adapter from the riser-
card assembly.
"Safety" on page v
"Removing the cover" on page
and
"Installation guidelines" on page
424).
.
Chapter 5
Removing and replacing components
447
Advertisement
Table of Contents
