Table of Contents
Advertisement
1. When you reassemble the components in the server, be sure to route all cables carefully so that they are
not exposed to excessive pressure.
2. When you replace the system board, you must either update the server with the latest firmware or
restore the pre-existing firmware that the customer provides on a diskette or CD image. Make sure that
you have the latest firmware or a copy of the pre-existing firmware before you proceed. See
the firmware" on page
"Updating the DMI/SMBIOS data" on page 531
Important: Some cluster solutions require specific code levels or coordinated code updates. If the device is
part of a cluster solution, verify that the latest level of code is supported for the cluster solution before you
update the code.
To install the system board, complete the following steps:
Step 1.
Read the safety information that begins on
417.
Step 2.
Align the system board with the chassis; then, lower the system board into the chassis and slide
the system board toward the rear of the server until the system board is seated firmly into the
locator pins on the chassis.
Figure 134. System board installation
Step 3.
Grasp the fan assembly brackets and rotate them down toward the chassis.
Step 4.
Reinstall the hot-swap fans (see
Step 5.
(Trained service technician only) Reinstall the microprocessor and heat sink (see
microprocessor and heat sink" on page
Step 6.
Reinstall the SAS/SATA RAID riser-card assembly base (see
card assembly" on page
513,
"Updating the Universal Unique Identifier (UUID)" on page
"Installing a hot-swap fan assembly" on page
502).
451).
for more information.
"Safety" on page v
and
"Installing the SAS/SATA RAID riser-
.
Chapter 5
Removing and replacing components
"Updating
530, and
"Installation guidelines" on page
461).
"Installing a
511
Advertisement
Table of Contents
