Table of Contents
Advertisement
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
Chapter 4 "Parts listing, Lenovo System x3550 M3 Type 4254 and 7944" on page 403
• See
components are customer replaceable units (CRU) and which components are field replaceable units (FRU).
• If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
Trained service technician.
• Go to the IBM support website at
tips, and new device drivers or to submit a request for information.
Symptom
A hard disk drive has failed,
and the associated amber hard
disk drive status LED is lit.
A newly installed hard disk
drive is not recognized.
Multiple hard disk drives fail.
http://www.ibm.com/supportportal/
Action
Replace the failed hard disk drive.
1. Make sure that the installed hard disk drive or RAID adapter is supported. For a
list of supported optional devices, see
x86servers/serverproven/compat/us/
2. Observe the associated amber hard disk drive status LED. If the LED is lit, it
indicates a drive fault.
3. If the LED is lit, remove the drive from the bay, wait 45 seconds, and reinsert the
drive, making sure that the drive assembly connects to the hard disk drive
backplane.
4. Observe the associated green hard disk drive activity LED and the amber status
LED:
• If the green activity LED is flashing and the amber status LED is not lit, the
drive is recognized by the controller and is working correctly. Run the DSA
diagnostics program to determine whether the drive is detected.
• If the green activity LED is flashing and the amber status LED is flashing
slowly, the drive is recognized by the controller and is rebuilding.
• If neither LED is lit or flashing, check the hard disk drive backplane (go to
step
Step
5).
• If the green activity LED is flashing and the amber status LED is lit, replace
the drive. If the activity of the LEDs remains the same, go to step
the activity of the LEDs changes, return to step
5. Make sure that the hard disk drive backplane is correctly seated. When it is
correctly seated, the drive assemblies correctly connect to the backplane
without bowing or causing movement of the backplane.
6. Reseat the backplane power cable and repeat steps
7. Reseat the backplane signal cable and repeat steps
8. Suspect the backplane signal cable or the backplane:
• If the server has eight hot-swap bays:
a. Replace the affected backplane signal cable.
b. Replace the affected backplane.
9. See
"Problem determination tips" on page
Make sure that the hard disk drive, SAS/SATA adapter, and server device drivers
and firmware are at the latest level.
Important: Some cluster solutions require specific code levels or coordinated code
updates. If the device is part of a cluster solution, verify that the latest level of code is
supported for the cluster solution before you update the code.
to determine which
to check for technical information, hints,
http://www.ibm.com/systems/info/
.
Step
2.
Step 2
through
Step 2
through
401.
Chapter 3
Step
5. If
Step
4.
Step
4.
.
Diagnostics
363
Advertisement
Table of Contents
