Table of Contents
Advertisement
The virtual media key has an LED. When this LED is lit and green, it indicates that the key is installed and
functioning correctly. When the LED is not lit, it indicates that the key might not be installed correctly.
The remote presence feature provides the following functions:
• Remotely viewing video with graphics resolutions up to 1600 x 1200 at 75 Hz, regardless of the system
state
• Remotely accessing the server, using the keyboard and mouse from a remote client
• Mapping the CD or DVD drive, diskette drive, and USB flash drive on a remote client, and mapping ISO
and diskette image files as virtual drives that are available for use by the server
• Uploading a diskette image to the IMM memory and mapping it to the server as a virtual drive
The blue-screen capture feature captures the video display contents before the IMM restarts the server when
the IMM detects an operating-system hang condition. A system administrator can use the blue-screen
capture to assist in determining the cause of the hang condition.
Enabling the remote presence feature
Use this information to enable the remote presence feature.
To enable the remote presence feature, complete the following steps:
Step 1.
Install the virtual media key into the dedicated slot on the system board (see
optional device connectors" on page
Step 2.
Turn on the server.
Note: Approximately 20 to 40 seconds after the server is connected to power, the power-control
button becomes active.
Obtaining the IP address for the IMM
To access the web interface, you need the IP address for IMM. You can obtain the IMM IP address through
the Setup utility. The server comes with a default IP address for the IMM of 192.168.70.125.
To locate the IP address, complete the following steps:
Step 1.
Turn on the server.
Note: Approximately 20 to 40 seconds after the server is connected to power, the power-control
button becomes active.
Step 2.
When the prompt <F1> Setup is displayed, press F1. (This prompt is displayed on the screen for
only a few seconds. You must press F1 quickly.) If you have set both a power-on password and an
administrator password, you must type the administrator password to access the full Setup utility
menu.
Step 3.
From the Setup utility main menu, select System Settings.
Step 4.
On the next screen, select Integrated Management Module.
Step 5.
On the next screen, select Network Configuration.
Step 6.
Find the IP address and write it down.
Step 7.
Exit from the Setup utility.
Logging on to the Web interface
Use this information to log on to the web interface.
System x3550 M3Problem Determination and Service Guide
524
22).
"System-board
Advertisement
Table of Contents
