Table of Contents
Advertisement
Prefix: PLAT ID: 0131
User Response
1. Make sure the DIMM is installed correctly. 2. If the DIMM was disabled because of a memory fault
(memory uncorrectable error or memory logging limit reached), follow the suggested actions for that
error event and restart the server. 3. Check the IBM support website for an applicable retain tip or
firmware update that applies to this memory event. If no memory fault is recorded in the logs and no
DIMM connector error LED is lit, you can re-enable the DIMM through the Setup utility or the
Advanced Settings Utility (ASU). One of the DIMMs :
• 806f0413-2582xxxx : A PCI PERR has occurred on system [ComputerSystemElementName]. (PCIs)
This message is for the use case when an implementation has detected a PCI PERR.
May also be shown as 806f04132582xxxx or 0x806f04132582xxxx
Severity
Error
Serviceable
Yes
Automatically notify support
No
Alert Category
Critical - Other
SNMP Trap ID
50
CIM Information
Prefix: PLAT ID: 0232
User Response
1. Check the PCI LED. 2. Reseat the affected adapters and riser cards. 3. Update the server firmware
(UEFI and IMM) and adapter firmware. Important: Some cluster solutions require specific code levels
or coordinated code updates. If the device is part of a cluster solution, verify that the latest level of
code is supported for the cluster solution before you update the code. 4. Remove both adapters. 5.
Replace the PCIe adapters. 6. Replace the riser cards.
• 806f0507-0301xxxx : [ProcessorElementName] has a Configuration Mismatch. (CPU 1)
This message is for the use case when an implementation has detected a Processor Configuration
Mismatch has occurred.
May also be shown as 806f05070301xxxx or 0x806f05070301xxxx
Severity
Error
Serviceable
Yes
Automatically notify support
No
Alert Category
Critical - CPU
SNMP Trap ID
40
.
Chapter 3
Diagnostics
151
Advertisement
Table of Contents
