Brake Cross Shaft Installation - Toro Z580 DFI Z Master Service Manual

Brake Cross Shaft Installation

1. Slide the brake cross shaft into position (Fig. 138).
Note: The end of the cross shaft with two tabs is
installed on the left side of the machine.
Fig 138
2. Position a flange bearing onto each end of the cross
shaft with the flange facing outward (Fig. 139).
Fig 139
Z580/Z589 DFI Z Master Service Manual
3. Position the flange bearing on the right end of the
cross shaft and install 2 bolts and nuts securing the
flange bearing to the frame (Fig. 140).
PICT-2964a
4. Position the flange bearing to the left side of the
frame and install 2 bolts and nuts to secure the
flange bearing to the frame (Fig. 141).
PICT-2970a
CHASSIS
Fig 140 PICT-2958a
Fig 141 PICT-2960a
3
3-39