Toro Z580 DFI Z Master Service Manual page 204

11. Remove the tapered roller bearing from the bottom
of the spindle (Fig. 599).
Fig 599
12. Using a hammer and a driver with a square edge,
drive both the top and bottom bearing races out of
the spindle housing (Fig. 600).
Fig 600
Z580/Z589 DFI Z Master Service Manual
13. Remove the large spacer in the spindle housing (Fig.
601).
DSC-2680a
14. This view shows the 2 bearing races and the large
spacer in the spindle housing (Fig. 602). Note the
internal snap ring in the housing; it is not necessary
to remove it when installing new bearing races and
the spacer.
DSC-2681a
A. Bearing Race
MOWER DECKS
Fig 601
A
B
Fig 602
B. Spacer
DSC-2682a
7
A
DSC-2684a
7-15