CHASSIS
5. Ensure the brake cross shaft rotates freely in the
flange bearings.
6. Install the clevis spring pin securing the brake rod
linkage yoke to the right side of the brake cross shaft
(Fig. 142).
3
7. Install the two clevis spring pins securing the brake
rod linkage yokes to the left side of the brake cross
shaft (Fig. 143).
3-40
Fig 142
PICT-2956a
Fig 143
PICT-2954a
8. Install the left and right rear tires and lower the
machine to the ground (Fig. 144).
Fig 144
9. Lower the seat.
10. Adjust the parking brake. Refer to "Adjusting the
Parking Brake" on page 3-65.
Z580/Z589 DFI Z Master Service Manual
PICT-2919a