Toro Z580 DFI Z Master Service Manual page 79

CHASSIS
13. Thread the yoke onto the neutral return bolt (Fig.
209).
3
14. Position the neutral return yoke to the right hand
motion control tab and install a clevis pin. Install a
cotter pin into the clevis pin to secure (Fig. 210).
3-58
Fig 209 PICT-3145a
Fig 210 PICT-3081a
15. Tighten the jam nut to secure the yoke (Fig. 211).
Note: The neutral return spring may need adjust­
ment after the motion contol levers are instal­
led. The motion control lever, when moved to
reverse position, should spring back to the
neutral postions when the handles are let go.
Fig 211
16. Install the bolt, washer and nut securing the right
hand control rod assembly to the right hand motion
control assembly (Fig. 212).
Note: The washer is installed between the ball joint
and motion control assembly tab.
Fig 212
Z580/Z589 DFI Z Master Service Manual
PICT-3149a
PICT-3151a