Toro Z580 DFI Z Master Service Manual page 96

3. Repeat steps 1 and 2 to install the other control arm
to the opposite pump control shaft.
4. Position the pump mounting bracket to the pump.
Loosely install 2 bolts, washers and nuts securing
the pump mounting bracket to the pump (Fig. 265).
Fig 265
5. Lower the mower deck to the lowest height-of-cut
position.
6. From under the machine, position the pump input
shaft through the hole in the frame (Fig. 266).
Fig 266
Z580/Z589 DFI Z Master Service Manual
HYDRAULIC SYSTEM
7. Align the pump mounting bracket to the frame and
loosely install 2 bolts, washers and nuts (Fig. 267).
8. Position the pump shield plate over the pump shaft,
PICT-4204a
against the frame. Install 2 two bolts, washers and
nuts securing the pump shield plate and pump to the
frame (Fig. 268).
PICT-3309a
Fig 267 PICT-3312a
Fig 268 PICT-3257a
4
4-9