Brake Latch Shaft - Toro Greensmaster 1018 Service Manual

Brake Latch Shaft

g260416
1. Shoulder bolt
2. Flange bushing (2 each)
3. Lever
4. Brake lock lever
5. Roll pin
6. Bolt
Disassembling the Brake Latch Shaft
Controls, Wheels and Accessories : Service and Repairs
Note: Refer to Figure 57
1. Park the machine on a level surface. Ensure that the engine is OFF and
the traction control is in NEUTRAL.
2. Remove the spark plug wire from the engine spark plug.
3. Remove the bolts and washers that secures the controls covers to the upper
receiver weldment.
4. Using the drift pin, remove the roll pin (5) from the brake lock lever (4).
5. Slide and remove the brake lock lever (4) from the brake latch shaft (9).
Figure 57
7. Flange bushing (2 each)
8. Flange nut
9. Brake latch shaft
10. Torsion spring
11. Flange nut
12. Upper receiver weldment
during this procedure.
Page 7–16 Greensmaster ® 1018/1021/1026
18238SL Rev B