How It Works
The hour meter is made up of an electric "winder" and a
mechanical clock movement. When power is applied, a
coil is energized to wind the movement. The movement
unwinds in about 2 seconds. As it finishes its rotation, it
re-energizes the coil so that the cycle can start over (Fig.
541).
Fig 541
Testing
Verify that 12 volts DC is present across the two termi-
nals when the engine is running. If there is no continuity,
replace the hour meter. The meter is a permanently
sealed unit and is not repairable.
Z580/Z589 DFI Z Master Service Manual
Electric PTO Clutch
Purpose
The electric clutch controls the engagement and disen-
gagement of the Power Take-off (PTO) pulley.
Location
The electric PTO clutch is located on the flywheel end of
the crankshaft (Fig. 542).
DSC-2560a
ELECTRICAL
Fig 542
PICT-4187a
6
6-17