Strut Installation
1. Install the balljoint and jam nut into the strut. The
length of the strut should be 17.31" (43.97cm) from
the center of the balljoint to the center of the cross
shaft of the strut (Fig. 737).
A
Fig 737
A. Strut
B. Jam nut
Z580/Z589 DFI Z Master Service Manual
D
B C
fig. 108-5969
C. Balljoint
D. 17.31" (43.97cm)
MOWER DECKS
2. Tighten the jam nut to secure the balljoint position
(Fig. 738).
Note: Position balljoint perpendicular to strut.
Fig 738
3. Install 2 grease fittings into the strut (Fig. 739).
Fig 739
PICT-4119a
7
PICT-4116a
7-53