HYDRAULIC SYSTEM
12. Check the distance from bottom of the slot in the nut
to the inside edge of the hole. Two threads or less
should be showing (Fig. 317).
4
A. Slotted nut
B. Two threads or less
showing
4-24
B
Fig 317
fig. 48 G001051 b
C. Hole in threaded shaft
Note: If more than two threads are showing remove
nut and install washer between hub and nut
and then:
a. Torque the slotted nut to 125 ft-lbs. (170 Nm)
(Fig. 318).
A
b. If necessary, tighten the nut until the next set of
slots line up with the hole in the shaft (Fig. 318).
D
C
A. Slotted nut
B. Two threads or less
showing
B
Fig 318
fig. 48 G001051 a
C. Hole in threaded shaft
D. Washer (if needed)
Z580/Z589 DFI Z Master Service Manual
A
C