Motion Control Assembly Installation - Toro Z580 DFI Z Master Service Manual

22. Position the right hand control lever to the right
hand control shaft arm. Install 2 bolts, and washers
securing the right hand lever to the control shaft arm
(Fig. 221).
Fig 221
23. Adjust the control handle neutral position. Refer to
"Adjusting the Control Handle Neutral Position" on
page 4-27.
24. Adjust the hydrostatic pump neutral. Refer to "Set-
ting the Hydrostatic Pump Neutral" on page 4-28.
Z580/Z589 DFI Z Master Service Manual

Motion Control Assembly Installation

25. Insert the pocket into the traction frame (Fig. 222).
PICT-3064a
26. Install 2 top pocket mounting bolts, washers and
nuts and 2 bottom pocket mounting bolts and nuts
(Fig. 223).
Note: Raise the seat to install the top 2 bolts,
washers and nuts.
B
A. Bolt, washer, nut
CHASSIS
Fig 222
A
A
Fig 223
B. Bolt, nut
3
PICT-3057a
B
PICT-3055a
3-61