Juniper M10i Hardware Manual page 133

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
If a Routing Engine is installed in the same row as the HCM you are removing, remove
2.
the Routing Engine first. If two Routing Engines are installed, use one of the following
two methods to determine which is functioning as master:
Note which of the blue
Issue the following CLI command. The master Routing Engine is designated
in the Current state field:
user@host> show chassis routing-engine
Routing Engine status:
Slot 0:
Current state
Election priority
Temperature
CPU temperature
DRAM
Memory utilization
CPU utilization:
User
Background
Kernel
Interrupt
Idle
Model
Serial ID
Start time
Uptime
Load averages:
Routing Engine status:
Slot 1:
Current state
Election priority
Temperature
CPU temperature
DRAM
Memory utilization
CPU utilization:
User
Background
Kernel
Interrupt
Idle
Model
Serial ID
Start time
Uptime
If you are removing the master Routing Engine and a second Routing Engine is installed,
3.
issue the following CLI command to switch mastership to the backup host module:
user@host> request chassis routing-engine master switch
Chapter 15: Replacing M10i Hardware Components
LEDs is lit on the Routing Engine faceplates.
MASTER
Master
Master (default)
27 degrees C / 80 degrees F
27 degrees C / 80 degrees F
768 MB
45 percent
0 percent
0 percent
3 percent
0 percent
97 percent
RE-5.0
1000647001
2009-01-28 14:11:50 PST
21 hours, 51 minutes, 16 seconds
1 minute
0.00
Backup
Backup (default)
26 degrees C / 78 degrees F
27 degrees C / 80 degrees F
1536 MB
23 percent
0 percent
0 percent
0 percent
0 percent
99 percent
RE-850
1000648260
2009-01-28 16:18:12 PST
19 hours, 44 minutes, 51 seconds
Master
5 minute 15 minute
0.02 0.00
107