Troubleshooting The M10I Hcm; Troubleshooting The M10I Routing Engine; Table 12: Chassis Alarm Messages - Juniper M10i Hardware Manual

M10i Multiservice Edge Router Hardware Guide

Table 12: Chassis Alarm Messages

Chassis
Component
Hot swapping
Related
Documentation

Troubleshooting the M10i HCM

Problem
Solution
Related
Documentation

Troubleshooting the M10i Routing Engine

Problem
Solution
88
All manuals and user guides at all-guides.com
Alarm
Severity Alarm Condition
Red Too many hot-swap
interrupts are occurring.
This message generally
indicates that a hardware
component that plugs
into the router's midplane
from the front is broken.
Displaying M10i Router Components and Serial Numbers on page 207
M10i Router Physical Specifications on page 183
M10i Routing Engine 400 LEDs on page 19
M10i Routing Engine 850 LEDs on page 21
The HCM is not functioning normally.
A green LED labeled PWR reports the status of the HCM. When an HCM is functioning
correctly, the green LED labeled
Table 6 on page 23.
M10i High-Availability Chassis Manager (HCM) Description on page 21
Installing an M10i HCM on page 109
M10i HCM Alarm LEDs on page 23
M10i HCM LEDs on page 23
The Routing Engine is not functioning normally.
A green LED labeled
ONLINE
Engine is functioning correctly, the green LED labeled
information, see Table 5 on page 21. To troubleshoot a Routing Engine:
Check the alarm LEDs on the HCM.
1.
Issue the
show chassis alarms
2.
the alarm cause:
user@host> show chassis alarms
For a list of messages that can appear in the output, see Table 13 on page 89.
Remedy
Contact technical
support. See
"Contacting Customer
Support" on page 212
for more information.
is lit steadily. For more information, see
OUTPUT OK
reports the status of the Routing Engine. When a Routing
ONLINE
CLI command to view a more detailed description of
Copyright © 2010, Juniper Networks, Inc.
is lit steadily. For more