Installing An M10I Cfeb Or Cfeb-E; Figure 36: Removing A Cfeb Or Cfeb-E; Figure 37: Installing A Cfeb Or Cfeb-E - Juniper M10i Hardware Manual

Installing an M10i CFEB or CFEB-E

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com

Figure 36: Removing a CFEB or CFEB-E

To install a CFEB or CFEB-E (see Figure 37 on page 105):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Verify that the ends of the ejector levers are pulled outward to a position nearly
2.
perpendicular to the faceplate of the CFEB or CFEB-E.
Place one hand under the CFEB or CFEB-E to support it and grasp one of the ejector
3.
levers at the front with the other hand.
Align the rear of the CFEB or CFEB-E with the guides inside the chassis and slide it in
4.
completely.
Press the ejector lever at each end of the CFEB or CFEB-E inward.
5.
Tighten the thumbscrew on each ejector lever (shown in "M10i CFEB and CFEB-E
6.
LEDs" on page 14) to seat the CFEB or CFEB-E firmly in the chassis.
Press the online/offline button on the CFEB or CFEB-E faceplate and hold it down
7.
until the green LED labeled
You can also verify correct CFEB or CFEB-E functioning by issuing the
commands described in "Maintaining the M10i CFEB and CFEB-E" on page 79.

Figure 37: Installing a CFEB or CFEB-E

Chapter 15: Replacing M10i Hardware Components
OUTPUT OK lights steadily.
show chassis cfeb
105