M10I Router Installation Safety Guidelines And Warnings; M10I Chassis Lifting Guidelines; Figure 63: Placing A Component Into An Electrostatic Bag - Juniper M10i Hardware Manual

Related
Documentation

M10i Router Installation Safety Guidelines and Warnings

M10i Chassis Lifting Guidelines

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
Appendix A: Safety and Regulatory Compliance Information for the M10i Router
on page 151). If you are returning a component, place it in an electrostatic bag before
packing it.

Figure 63: Placing a Component into an Electrostatic Bag

M10i Chassis Description on page 5
M10i Chassis Lifting Guidelines on page 151
Installation Safety Warnings for M Series, MX Series, and T Series Routers on page 152
The weight of a fully configured chassis is about 79 lb (35.8 kg). Observe the following
guidelines for lifting and moving the router:
Before moving the router, read the guidelines in "M10i Router Site Preparation Checklist"
on page 39 to verify that the intended site meets the specified power, environmental,
and clearance requirements.
Do not attempt to lift a fully configured router by yourself. Using a mechanical lift to
maneuver the router into a rack is recommended. If a lift cannot be used, a minimum
of two people must lift the router.
Before lifting or moving the router, disconnect all external cables.
As when lifting any heavy object, lift most of the weight with your legs rather than your
back. Keep your knees bent and your back relatively straight and avoid twisting your
body as you lift. Balance the load evenly and be sure that your footing is solid.
General Safety Guidelines for M Series, MX Series, and T Series Routers on page 147
Installation Safety Warnings for M Series, MX Series, and T Series Routers on page 152
Maintenance and Operational Safety Warnings for M Series, MX Series, and T Series
Routers on page 161
151