Juniper M10i Hardware Manual page 82

M10i Multiservice Edge Router Hardware Guide
56
All manuals and user guides at all-guides.com
First, perform the following prerequisite procedures:
Verify that the router site meets the requirements described in "M10i Router Site
Preparation Checklist" on page 39.
Place the rack in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure. For details, see "Installation Safety
Warnings for M Series, MX Series, and T Series Routers" on page 152.
Read the following installation safety guidelines and warnings:
M10i Chassis Lifting Guidelines on page 151
Installation Safety Warnings for M Series, MX Series, and T Series Routers on page 152
Remove the router from the shipping carton, as described in "Unpacking the M10i
Router" on page 47.
Then perform the following procedures to install the router (see Figure 24 on page 57
and Figure 25 on page 58):
If you are center-mounting the router, move the mounting brackets on the chassis
1.
from the front-mounting position to the center-mounting position. For instructions,
see "Moving the Mounting Brackets" on page 51.
Position the chassis at the appropriate height in the rack:
2.
If using a mechanical lift, load the router onto the lift, making sure it rests securely
on the lift platform. Use the lift to raise the chassis to the correct height.
If not using a mechanical lift, have one person stand behind the router and another
person in front. Grasp the chassis, lift it, and position it at the correct height. Have
a third person ready to install the mounting screws.
Align the bottom hole in both mounting brackets with a hole in each rack rail, making
3.
sure the chassis is level.
Install a mounting screw into each of the two aligned holes. Use a Phillips screwdriver
4.
to tighten the screws.
Moving up the router, install a mounting screw into the remaining holes in each
5.
mounting. At least two screws in each mounting bracket are required, at the top and
bottom of the mounting bracket.
Verify that the router is level.
6.
If using a mechanical lift, move it away from the rack.
7.
To continue the installation, proceed to "Initially Configuring the M10i Router" on
8.
page 73.
Copyright © 2010, Juniper Networks, Inc.