Configuring The Compactflash Card On An M10I Routing Engine; Figure 58: Inserting The Compactflash Card - Juniper M10i Hardware Manual

M10i Multiservice Edge Router Hardware Guide
Related
Documentation

Configuring the CompactFlash Card on an M10i Routing Engine

138
All manuals and user guides at all-guides.com
Orient the CompactFlash card with the Juniper Networks logo facing up. Slide the
3.
CompactFlash card into the connector on the Routing Engine (see Figure 58 on
page 138).
NOTE: If there is no Juniper Networks logo on the CompactFlash card,
orient the CompactFlash card so that the manufacturer's product code
sticker is facing down.
Use needlenose pliers with grooved jaws to lower and secure the wire clasp.
4.
Install the Routing Engine as described in "Installing the M10i Routing Engine" on
5.
page 134.

Figure 58: Inserting the CompactFlash Card

Wire clasp
Preventing Electrostatic Discharge Damage to an M10i Router on page 150
Installing the M10i Routing Engine on page 134
M10i Routing Engine Architecture Overview on page 33
Maintaining the M10i Routing Engine on page 83
Troubleshooting the M10i Routing Engine on page 88
After installing the CompactFlash card for the first time, you must copy the software
from the Routing Engine's hard disk to the CompactFlash card.
To copy software to the CompactFlash card, perform the following procedure:
Install the CompactFlash card and replace the Routing Engine as described in"Installing
1.
the CompactFlash Card in an M10i Routing Engine" on page 137 and "Installing the M10i
Routing Engine" on page 134.
Log into the UNIX shell on your router, and change to the
2.
Format the CompactFlash card using the following commands:
3.
Routing Engine (front)
CompactFlash card
directory.
/var/tmp
Copyright © 2010, Juniper Networks, Inc.