CHAPTER 9
Grounding the M10i Router
Grounding the M10i Router
Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
Grounding the M10i Router on page 59
You must provide the grounding cable. For grounding cable specifications, see "M10i
Chassis Grounding Cable and Lug Specifications" on page 187. To connect the grounding
cable:
Verify that a licensed electrician has attached the two-hole cable lug provided with
1.
the router to the grounding cable.
Connect the grounding cable to a proper earth ground.
2.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
3.
the strap to one of the ESD points on the chassis.
Using a number 2 Phillips screwdriver, remove the screws next to the grounding symbol
4.
above the power supplies on the chassis rear (see Figure 26 on page 60). Secure the
grounding cable lug to the chosen grounding point by reinstalling and tightening the
screws.
Verify that the grounding cable is connected correctly, that it does not touch or block
5.
access to router components, and that it does not drape where people could trip on
it.
59