M10I Hcm Leds; M10I Hcm Alarm Leds; Figure 9: M10I High-Availability Chassis Manager; Table 6: States For Hcm Leds - Juniper M10i Hardware Manual

Related
Documentation

M10i HCM LEDs

Table 6: States for HCM LEDs

Label
PWR
MSTR
Related
Documentation

M10i HCM Alarm LEDs

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
(zero/zero) through
0/0
from 1/0 (one/zero) through
For PIC replacement instructions, see "Replacing an M10i PIC" on page 111.
M10i HCM Serial Number ID Label on page 209
M10i Router Physical Specifications on page 183
M10i Routing Engine Interface Ports on page 17

Figure 9: M10i High-Availability Chassis Manager

Two LEDs Indicate HCM status. There is a green LED labeled
. Table 6 on page 23 describes the LED states.
MSTR
Color State
Green On steadily
Blinking
Blue On steadily
M10i High-Availability Chassis Manager (HCM) Description on page 21
M10i HCM Alarm LEDs on page 23
M10i Chassis Description on page 5
Two alarm LEDs are located on the right of the HCM (see Figure 9 on page 23). The
circular red LED lights to indicate a critical condition that can result in a system shutdown.
The triangular yellow LED lights to indicate a less severe condition that requires monitoring
or maintenance. Both LEDs can be lit simultaneously.
, right to left. The PIC slots in the lower FPC are numbered
0/3
1/3 , right to left.
Description
HCM is functioning normally.
HCM is starting up.
HCM is master.
Chapter 2: M10i Hardware Components
and an blue LED labeled
PWR
23