Installing An M10I Sfp; Figure 45: Small Form-Factor Pluggable (Sfp) - Juniper M10i Hardware Manual

Installing an M10i SFP

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
the cable management system. Placing fasteners on the loop helps to maintain its
shape.
Pull the ejector handle away from the SFP faceplate to unseat the SFP from the PIC.
6.
Pull the SFP out of the PIC and place it on the antistatic mat or in the electrostatic
bag.
CAUTION: After removing a transceiver from the chassis, wait at least 30
seconds before reinserting it or inserting a transceiver into a different slot.

Figure 45: Small Form-Factor Pluggable (SFP)

Connector
Locking pin
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected
to a transceiver emit laser light that can damage your eyes.
CAUTION: When handling fiber-optic transceivers and fiber-optic cable,
observe the following precautions:
Do not leave a fiber-optic transceiver uncovered except when inserting or
removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
Do not bend fiber-optic cable beyond its minimum bend radius. An arc
smaller than a few inches in diameter can damage the cable and cause
problems that are difficult to diagnose.
Do not let fiber-optic cable hang free from the connector. Do not allow
fastened loops of cable to dangle, which stresses the cable at the fastening
point.
To install a replacement SFP (see Figure 46 on page 120):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Verify that a rubber safety cap covers the SFP transceiver, installing one if necessary.
2.
Chapter 15: Replacing M10i Hardware Components
119