M10I Cfeb And Cfeb-E Leds; Table 3: States For Cfeb Or Cfeb-E Leds - Juniper M10i Hardware Manual

M10i Multiservice Edge Router Hardware Guide
Related
Documentation

M10i CFEB and CFEB-E LEDs

Table 3: States for CFEB or CFEB-E LEDs

Label
OK
FAIL
14
All manuals and user guides at all-guides.com
Two 64-MB RLDRAMs for route lookup
Two 64-MB RLDRAMs for control memory
System interfaces:
100-Mbps link for internal interface to the Routing Engine
19.44-MHz reference clock—Generates clock signal for SONET/SDH PICs
I2C controller to read the I2C/EEPROMs in the PICs and temperature sensors
I2C/EEPROM containing the serial number and revision level
Two 512-KB boot flash EPROMs (programmable on the board)
One MPC8545 integrated processor with 1-GB DDR2 SDRAM
Three LEDs—A green LED labeled
indicate CFEB-E status.
MASTER
Offline button—Prepares the CFEB-E for removal from the router when pressed.
Ejector levers—Control the locking system that secures the CFEB-E in the chassis.
M10i Packet Forwarding Engine Architecture Overview on page 32
M10i Routing Engine Description on page 15
Configuring CFEB Redundancy on the M10i Router
Installing an M10i CFEB or CFEB-E on page 105
M10i Router Physical Specifications on page 183
Three LEDs—A green LED labeled
indicate CFEB-E status.
MASTER
Color State
Green On steadily
Blinking
Off
Red On steadily
Off
, a red LED labeled
OK
, a red LED labeled
OK
Description
CFEB/CFEB-E is running normally.
CFEB/CFEB-E is starting up.
CFEB/CFEB-E is offline or is functioning as the
backup CFEB/CFEB-E.
CFEB/CFEB-E is not operational or is in reset mode.
CFEB/CFEB-E is functioning properly
, and a blue LED labeled
FAIL
, and a blue LED labeled
FAIL
Copyright © 2010, Juniper Networks, Inc.