Chapter 6 Unpacking The M10I Router; Tools And Parts Required To Unpack The M10I Router; Unpacking The M10I Router - Juniper M10i Hardware Manual

CHAPTER 6

Unpacking the M10i Router

Tools and Parts Required to Unpack the M10i Router

Related
Documentation
Unpacking the M10i Router
Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
This chapter explains how to unpack the router and verify the parts received. It also
describes how to move the mounting brackets and install the cable management system.
Before beginning, prepare the installation site as described in "M10i Router Site Preparation
Checklist" on page 39. This chapter discusses the following topics:
Tools and Parts Required to Unpack the M10i Router on page 47
Unpacking the M10i Router on page 47
Verifying the M10i Router Parts Received on page 48
To unpack the router and prepare for installation, you need the following tools:
Utility knife for cutting the sealing tape on the shipping carton
Phillips (+) screwdriver, number 2
M10i Router Description on page 3
M10i Chassis Description on page 5
M10i Chassis Lifting Guidelines on page 151
The router is shipped in a cardboard carton, held in place with foam packing material.
The crate also contains an accessory box, the front-mounting shelf, and the Quick Start
.
NOTE: The router is maximally protected inside the shipping carton. Do not
unpack it until you are ready to begin installation.
To unpack the router, perform these steps:
Move the shipping carton to a staging area as close to the installation site as possible.
1.
Position the carton so that the arrows are pointing up.
2.
47