Figure 43: Installing A Pic - Juniper M10i Hardware Manual

M10i Multiservice Edge Router Hardware Guide
Related
Documentation
114
All manuals and user guides at all-guides.com
Arrange each cable in the cable management system to prevent the cable from
8.
dislodging or developing stress points. Secure the cable so that it is not supporting its
own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled
loop in the cable management system. Placing fasteners on the loop helps to maintain
its shape.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Use one of the following methods to bring the PIC online:
9.
Press and hold the PIC offline button until the status LED on the PIC faceplate
indicates normal functioning, which usually takes about 5 seconds. The LED is
usually green; for more information, see the M10i Multiservice Edge Router PIC Guide.
The offline button for each PIC is located on the HCM and is labeled with the PIC
slot number. The PICs in FPC
in FPC are located on the lower HCM.
1
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the Junos OS System Basics and
Services Command Reference.
The normal functioning status LED confirms that the PIC is online. You can also verify
correct PIC functioning by issuing the
in "Maintaining the M10i PICs and PIC Cables" on page 81.

Figure 43: Installing a PIC

Preventing Electrostatic Discharge Damage to an M10i Router on page 150
are located on the upper HCM, and the PICs installed
0
show chassis fpc pic-status
Copyright © 2010, Juniper Networks, Inc.
command described