HYOSUNG TE 450 Service Manual page 97

3-55 ENGINE
● Install the cam chain guide ① .
NOTE
Make sure that the guide ① ①
or binding of the cam chain and guide may result.
● Install the dowel pins ②
CAUTION
Use a new cylinder head gasket to prevent gas
leakage.
◉ ◉ CYLINDER HEAD
● With the head snugly seated on the cylinder,
secure it by tightening the bolts in diagonal
stages. Tighten the cylinder head bolts diagonally
to the specified torque.
Cylinder head bolt : 47 N∙ ∙ m (4.7 kgf∙ ∙ m)
NOTE
� � Apply engine oil to the threaded parts of the
cylinder head bolts and its washers.
� � Be sure to install the washer with rounded side
facing up.
● After tightening the cylinder head bolts to specifi-
cation, tighten the cylinder head base bolts ④
cylinder base nuts ⑤
Cylinder head base bolt
Cylinder base nut
◉ ◉ CAMSHAFT ASSEMBLY
● Turn the magneto rotor until the "T" line on the
magneto rotor is aligned with the triangle mark on
the crankcase.
CAUTION
If the crankshaft is turned without drawing the
cam chain upward, the cam chain will catch
between crankcase and cam chain sprocket.
is inserted properly
and new gasket ③ .
to the specified torque.
: 10 N∙ ∙ m (1.0 kgf∙ ∙ m)
: 10 N∙ ∙ m (1.0 kgf∙ ∙ m)
③
and
②
④
③ ⑤
①