HYOSUNG TE 450 Service Manual page 91

3-49 ENGINE
● Install the gearshift shaft ① .
● Install the circlip ② .
◉ ◉ OIL PUMP
● Before mounting the oil pump, apply engine oil to
the sliding surfaces of the oil pump case, outer
rotor, inner rotor, and crankcase.
● Apply a small quantity of THREAD LOCK "1324"
to the oil pump mounting screws, and then tighten
them securely.
THREAD LOCK " " 1324" "
● When installing the oil pump driven gear, align the
pin ③
with the groove.
◉ ◉ OIL PIPE
● Apply engine oil to the O-rings.
● Tighten the oil pipe bolt securely.
① ②
③
②