Fuel Pump - HYOSUNG TE 450 Service Manual

◉ ◉ REMOUNTING
Remount the fuel cock in the reverse order of
removal.
CAUTION
Tighten the fuel cock bolts evenly.

FUEL PUMP

◉ ◉ REMOVAL
● Remove the seat and fuel tank.
● Disconnect the fuel hoses ③ , ④
hose ⑤ .
● Remove the fuel pump mounting bolts.
◉ ◉ INSPECTION
WARNING
Gasoline is very explosive. Extreme care must be
taken.
● Disconnect the fuel hose ③ , connect the suitable
hose and insert the free end of the hose into a
receptacle.
Check the fuel flow when starting the engine for a
few seconds by pressing the starter switch.
If the fuel flow is not found, check the fuel cock.
(Refer to page 4-1)
If the fuel cock and hoses are not fault, replace the
fuel pump.
◉ ◉ REASSEMBLY
Carry out the assembly procedure in the reverse
order of disassembly.
● Tighten the fuel pump mounting bolts.
● Connect the fuel hoses ③ , ④
⑤
securely.
FUEL HOSE ROUTING :
Fuel hose ③ (To carburetor)
Fuel hose ④
(To fuel cock)
Vacuum hose ⑤
(To intake pipe).
and vacuum
and vacuum hose
③
③
FUEL SYSTEM 4-2
④
⑤
④
⑤