ENGINE REASSEMBLY
Reassemble the engine in the reverse order of disassembly.
Pay special attention to the following points :
Apply engine oil to each running and sliding part before reassembling the engine.
◉ ◉ CRANKSHAFT
● Determine the width between the webs referring to
the figure when rebuilding the crankshaft.
Width between
webs
71.0±0.1 mm (2.795±0.004 in)
● When mounting the crankshaft in the crankcase, it
is necessary to pull its left end into the crankcase
by using the special tools.
Crankshaft installer : 09910-32812
CAUTION
Never fit the crankshaft into the crankcase by
striking it with a plastic hammer.
Always use the special tool, otherwise the accu-
racy of the crankshaft alignment will be affected.
NOTE
Standard
ENGINE 3-44
71.0±0.1 ㎜