HYOSUNG TE 450 Service Manual page 222

7-69 CHASSIS
▣ ▣ REAR AXLE SHAFT
Measure the rear axle shaft runout.
If the runout exceeds the service limit, replace the
rear axle shaft with a new one.
Rear axle
shaft runout
Dial gauge : 09900-20606
Magnetic stand : 09900-20701
V-block : 09900-21304
NOTE
When measuring the runout, support the rear axle
shaft at 34 mm (1.34 in) diameter of the rear axle
shaft as shown in illustration.
Measure the runout at 40 mm (1.57 in) diameter of
the rear axle shaft as shown in illustration.
▣ ▣ DUST SEAL
Inspect the dust seals for wear or damage. If any
defect are founds, replace the dust seal with a new
one.
▣ ▣ AXLE BEARINGS
Inspect the play of the wheel bearings by finger while
they are in the axle housing.
Rotate the inner race by finger to inspect for abnor-
mal noise and smooth rotation.
Replace the bearing with a new one, if there is any-
thing unusual.
Service limit
6 mm (0.24 in)