Table of Contents
Advertisement
● Install the dowel pins ① .
● Place each camshaft housing and cam chain
guide into the correct position.
NOTE
Camshaft housing marked "EX" are for the
exhaust side and those marked "IN" are for the
intake side.
● Tighten the camshaft housing bolts to the speci-
fied torque.
Camshaft housing bolt
NOTE
When tightening the camshaft housing bolts, the
piston position must be at TDC on the compres-
sion stroke.
◉ ◉ CYLINDER HEAD COVER
● Thoroughly wipe off oil from the fitting surfaces of
the cylinder head and cover.
● Apply BOND "1215" to the end caps of the cylin-
der head cover gasket as shown.
BOND "1215"
● Apply engine oil to both sides of the washer ② .
● Lightly tighten the cylinder head cover bolts in
diagonal stages, and then tighten them to the
specified torque.
Cylinder head cover bolt
CAUTION
Use a new washers ② ② .
: 10 N∙ ∙ m (1.0 kgf∙ ∙ m)
: 14 N∙ ∙ m (1.4 kgf∙ ∙ m)
①
③
ENGINE 3-58
①
②
Hide quick links:
Advertisement
Table of Contents
