◉ ◉ REASSEMBLY AND REMOUNTING
Reassemble and remount the front suspension in the
reverse order of removal and disassembly.
Pay attention to the following points :
● Apply SUPER GREASE "A" to the dust seals, dust
covers and bearing.
SUPER GREASE "A"
● Install the bearings ① , dust seals ②
③
into the suspension arm.
● Install the spacers ④ , bearings ① , dust seals ②
and dust caps ⑤
into the suspension arm.
NOTE
Stamped mark on the dust seal ② ②
side.
● Degrease the tapered portion of knuckle and also
knuckle end with nonflammable cleaning solvent.
● Install the suspension arms to the steering knuck-
le and tighten the knuckle end nuts to the speci-
fied torque.
Knuckle end nut : 43 N∙ ∙ m (4.3 kgf∙ ∙ m)
● Install the cotter pins.
CAUTION
Replace the removed cotter pins with new ones.
and spacers
must face out-
②
UPPER
③
①
②
③
LOWER
②
⑤
② ①
⑤
④
CHASSIS 7-26
①
③
②
② ① ③
④
①
⑤
① ②
② ⑤
①