HYOSUNG TE 450 Service Manual page 90

◉ ◉ PRIMARY DRIVE GEAR AND
WATER PUMP DRIVE GEAR
● Install the primary drive gear to the crankshaft ① .
● Install the water pump drive gear ② .
● Apply engine oil to the thread and inside surface
of the nut.
● With the crankshaft held immovable using the
special tool, and then tighten the primary drive
gear nut ③ to the specified torque.
Primary drive gear nut
Conrod holder : 09910-20115
NOTE
This nut has left-hand thread.
CAUTION
Apply engine oil to the primary drive gear nut.
◉ ◉ GEARSHIFT CAM STOPPER
● Apply a small quantity THREAD LOCK "1324" to
the gearshift cam plate bolt ④ .
THREAD LOCK " " 1324" "
● Install the gearshift cam plate and gearshift cam
plate bolt ④ .
● Install the gearshift cam stopper ⑤
fied torque.
Gearshift cam stopper
: 140 N∙ ∙ m (14.0 kgf∙ ∙ m)
to the speci-
: 32 N∙ ∙ m (3.2 kgf∙ ∙ m)
③
④
⑤
ENGINE 3-48
①
②