Table of Contents
Advertisement
◉ ◉ REAR SHOCK ABSORBER
DISPOSAL
WARNING
� � The rear shock absorber unit contains high-
pressure nitrogen gas.
� � Mishandling can cause explosion.
� � Keep away from fire and heat. High gas pres-
sure caused by heat can cause an explosion.
� � Release gas pressure before disposing.
▣ ▣ GAS PRESSURE RELEASE
● Remove the valve cap.
● Press the valve with a screwdriver to bleed out the
nitrogen gas.
WARNING
� � Releasing high pressure gas from the rear
shock absorber unit can be hazardous. Never
perform any servicing until the nitrogen gas
pressure has been released from the rear
shock absorber unit.
� � When releasing the gas pressure, place a rag
over the gas valve and use the tip of a screw-
driver to press the valve. Do not use your fin-
ger to depress the gas valve, and be sure to
direct the valve away from your face and body.
� � Be sure to always wear eye protection when
performing this procedure.
◉ ◉ REMOUNTING
Remounting the rear shock absorber in the reverse
order of removal. Pay attention to the following points :
● Tighten each bolt/nut to the specified torque.
Rear shock absorber nut (Upper) ① ①
Rear shock absorber nut (Lower) ② ②
Rear cushion rod nut ③ ③
: 70~100 N∙ ∙ m (7.0~10.0 kgf∙ ∙ m)
: 40~60 N∙ ∙ m (4.0~6.0 kgf∙ ∙ m)
: 40~60 N∙ ∙ m (4.0~6.0 kgf∙ ∙ m)
①
②
CHASSIS 7-56
③
Hide quick links:
Advertisement
Table of Contents
