HYOSUNG TE 450 Service Manual page 193

◉ ◉ TOE-IN ADJUSTMENT
Adjust the toe-in as follows :
● Place the vehicle on level ground and set the han-
dlebar straight.
Make sure all the tires are inflated to the standard
pressure. (Refer to page 2-18)
● Place 75 kg (165 lbs) of weight on the seat.
● Loosen the lock nuts ( ① , ② ) on each tie rod.
CAUTION
The lock nuts ① ①
have left-hand threads.
● Measure the distances (� and �) between the
front wheels. Subtract the measurements of �
from the measurements of � to find the toe-in.
If the toe-in is not within specification, adjust the
tie rod to the right or left until the toe-in is within
the specified range.
Toe-in
[When apply to a load 75 kg (165 lbs)]
NOTE
� � - � � = Toe-in
● Temporarily tighten the four lock nuts.
● Check that the distances (� and �) are equal, as
shown.
If the distances are not equal, adjust the tie rod to
the right or left until the toe-in is within specifica-
tion.
Check the toe-in again by measuring distances �
and �.
● If the toe-in is not within specification, repeat the
adjustment as above until the proper toe-in is
obtained and distances � and � become equal.
● After adjustment has been made, tighten the four
lock nuts ①
to the specified torque.
Tie rod lock nut : 29 N∙ ∙ m (2.9 kgf∙ ∙ m)
Standard
0 ~ 5 mm (0 ~ 0.2 in)
②
①
�
Forward
Tire side
CHASSIS 7-40
①
②
�
Tire side