HYOSUNG TE 450 Service Manual page 31

2-15 PERIODIC MAINTENANCE
● Remove the rear master cylinder pin.
● Turn the adjuster � in or out until the pedal play
� to the specification, after loosening the lock nut
�.
● Make sure to tighten the lock nut � securely.
Brake pedal play � �
Rear brake master cylinder rod lock nut
: 10~20 N∙ ∙ m (1.0~2.0 kgf∙ ∙ m)
● Adjust the brake switch so the brake light comes
on when the brake pedal is depressed 7 ~ 10 mm
(0.3 ~ 0.4 in).
▣ ▣ PARKING BRAKE
Parking brake adjustment may be required if the
parking brake does not work properly. Every time the
brake pads are replaced, adjust the parking brake.
● Park the ATV on level ground.
● Check the front wheels.
● Lift the rear end of the ATV and place a block
under swingarm.
● Loosen the parking brake adjuster lock nut �.
● Loosen the parking brake adjuster �.
● Loosen the parking brake cable adjuster lock nut
�, �.
● Turn the adjuster �, �, �, so that the cable
length � is 54 ~ 58 mm (2.1 ~ 2.3 in).
0 ~ 10 mm (0 ~ 0.4 in)
�
�
�
�
�
�
�